Configuration Stages
To configure the Qualigen FastPack IP System to connect to Relaymed the following configuration stages are required:
- Configure the Qualigen FastPack IP System Device Settings
- Qualigen FastPack IP System Connection Configuration
- Lantronix Configuration for Ethernet
- Digi Edgeport connection for Direct PC
- Add device to Relaylink.
Stage One: Configure Device
To allow the Qualigen FastPack IP System to communicate with Relaymed the following settings are required:
- Language Units: English 2
- Output: To Computer
Step 1: From the Main Menu use the Red button to cycle through menu options to Language Units setting.
Step 2: Press the Blue button to enter the Language Units menu.
Step 3: Press the Red button to cycle through the options until "English 2" is displayed.
Step 4: Press the Blue button to save the setting.
Step 5: Press the Red button until "Results =" is displayed. Press the blue button until "Computer" is selected.
Note: In some devices, this menus option may read "Set to Computer" or "Set to Printer". If this is the case, follow the below steps:
- If "Set to Computer" is displayed press the Blue button to change the setting.
- The Display will then briefly show "COM1 - Computer" before returning to the Home Screen.
- If "Set to Printer" is displayed the device is correctly configured.
Step 6: Press the Red button until "Exit" is displayed.
Step 7: Press the Blue button to exit the menu and save the settings.
Ethernet Connection
Stage Two: Lantronix Configuration (Ethernet Connection Only)
Step 1: Connect the Qualigen FastPack IP Serial Cable to the COM 1 port on the rear of the Qualigen FastPack IP.
Step 2: Connect the Male-to-Male Null Modem adapter to the Qualigen FastPack IP Serial Cable.
Step 2: Connect the Lantronix xDirect to the Male-to-Male Null Modem adapter.
Step 3: Follow the Lantronix xDirect configuration Guide to correctly configure the adapter to connect to your network.
Stage Three: Add Device to Relaylink
To add the Qualigen FastPack IP to the Relaylink follow the Add Ethernet device to Relaylink Guide
Direct PC Connection
Stage Two: Digi Edgeport Connection (Direct PC Connection Only)
Step 1: Connect the Qualigen FastPack IP data cable to the device.
Step 2: Connect the Digi Edgeport to the Qualigen FastPack IP data cable and an available USB port on the PC.
Step 3: Record the Serial Number on the Digi Edgeport Adapter, this will be required to add the device to the Relaylink.
Stage Three: Add Device to Relaylink
To add the Qualigen FastPack IP to the Relaylink follow the Add Serial device to Relaylink Guide
___________________________________________________________________________________
Article for Qualigen FastPack IP Version 2 Configuration Guide