Skip to content
  • There are no suggestions because the search field is empty.

NanoEnTek FREND System

Configuration Guide

Step 0: Before you start

  1. Make sure you have a Lantronix xDirect232 - Serial to Ethernet Convertor 
  2. Make sure you have a Null Modem Connector.
    1. This cable requires male to male:
      Female_Frend_cable.JPG
  3. Make sure you have current Relaylink version. You can Download it here.

Step 1: Add device to the Relaylink

To add the NanoEnTek FREND to the Relaylink follow the Add Ethernet device to Relaylink guide

Step 2: Connect device to the network

  • Connect the Lantronix serial to the device
    Frend_connector_setup.JPG
  • Connect the Lantronix ethernet to your network

Step 3: Configure Lantronix

Follow the instructions here to set up set the Lantronix Serial settings.

Step 4: Send a test through

To verify the setup works send a test from the device to Relaymed.