Skip to content
  • There are no suggestions because the search field is empty.

HemoCue Hb 201+

Configuration Guide

Configuration Stages

To configure the HemoCue Hb 201+  to connect to Relaymed the following configuration stages are required:

  1. HemoCue Driver Installation
  2. Add device to Relaymed Software Agent.
  3. Connect HemoCue Hb 201+ to the Computer using a USB Cable

Stage One: Device Driver Installation

Note: Ensure the HemoCue Hb 201+ is not connected to the PC before starting the driver installation

Step 1: Download the device driver installer.

Supported Operating Systems:

  • Windows 7 (x86 and x64)
  • Windows 8.1 (x86 and x64)
  • Windows 10 (x86 and x64)
  • Windows Server 2008 
  • Windows Server 2012 
  • Windows Server 2016 

Step 2: Extract the Zipped Device Driver Installation Files.

Step 3: Run setup.exe to start the Device Driver Installation Wizard.

Stage Two: Add Device to Relaylink

To add the HemoCue Hb 201+ to the Relaylink follow the Add USB device to Relaylink guide

Stage Three: Connect Hb 201+ to PC

Connect the HemoCue Hb 201+ to the Computer using a USB Cable and power the device on to connect the device to the Relaylink.

Stage Four: Send a test through 

*Test results that flow to the portal will require an end user to log into the Relaymed portal and manually update the MRN before sending the result to the EHR. 

  • There is no ability to add an MRN or any other identifiable information to the Hb 801, therefore each test requires manual input of the MRN in the Relaymed Portal.