Skip to content
  • There are no suggestions because the search field is empty.

CoaguSense, Inc. Coag-Sense PT2 

Configuration Guide

Add Device to the Relaymed Link or Relaymed Software Agent

For practices using the Relaymed Link, log in to your Relaymed Portal and follow these steps:

Adding a Device to Relaymed Link

For practices using the Relaymed Software Agent, open the server or PC where the agent is installed and follow these steps:

Adding a Device to Software Agent

Back to the device - Connect the device to your network

Step 1: Connect the CoaguSense Pt2 to the Ethernet port on the back of the device. Connect the other end to an active Ethernet wall port or switch.

Stage 1: Configure Device Network Settings

Step 1: Make sure the user is logged in under the administrator account. The administrator login info is provided by the manufacturer at the time of purchase and is included in the package when shipped. 

Step 2: Select the Settings menu and then select Data Transfer.  Select POCT1-A, select Confirm to save and return to the previous menu.  

Step 3: Ensure that the Ethernet cable is plugged in to the CAT-45 Port on the back of the device to use this 'Wired' selection.  

Step 4: Look for Communication settings and select Wired Connection.           

Step 5: Under Wired settings, select either DHCP or Manual (Static). If DHCP is selected, no further action is needed.  If Manual (Static) IP is selected, you will need to fill in the required fields in the menu.  This information can be found by contacting your IT Dept or third-party IT Support.  Select Confirm to save and return. 

Step 6: Select Server and input the Host IP address, this is the computer/server on which the Relaymed software agent is installed.  Next, input the Port number that was entered when setting up the device on the Relaymed software agent. This information can be found by contacting your IT Dept or third-party IT Support.  Once completed, select Connect.  

Note:  A restart of the device is suggested and may be required. 

Stage 2: Send a test

Verify the setup is working by sending a test to Relaymed.

Test data is sent automatically once the device completes the test.